Mitsubishi GOT1000 GT15 - Page 128

6 - 10
6.3 Mounting Position
(e) For GT155
The control panel side installation unit cannot be installed within 25mm (0.98inch) from the
GOT.
When the CF card interface of the GOT (A drive) is used, the unit cannot be installed in the
area of 100mm wide by 68mm long on the right side of the hole for installing the GOT in the
rear view.
A CF card cannot be inserted and ejected.
When the other extension units are used, the control panel side installation unit cannot be
installed in the areas shown in the following figure.
X
80
100
40
68
Hole for
installing
GOT
(View from the
rear side)
Prohibited area for installation
with an extension unit
(3.15)
(1.57)
(3.94)
(2.68)
Prohibited area
for installation
with CF card
interface (A drive)
Extension unit Model
X
(Unit:
mm(inch))
Bus connection unit
GT15-ABUS, GT15-ABUS2,
GT15-75ABUSL, GT15-75ABUS2L
57.5(2.26)
GT15-QBUS, GT15-QBUS2,
GT15-75QBUSL,
GT15-75QBUS2L
79(3.11)
Serial communication unit
GT15-RS2-9P, GT15-RS4-9S 56.5(2.22)
GT15-RS4-TE
-
*
Ethernet communication unit GT15-J71E71-100
MELSECNET/H communication
unit
GT15-J71LP23-25 78(3.07)
GT15-J71BR13 71(2.80)
CC-Link IE Controller Network
communication unit
GT15-J71GP23-SX 64(2.52)
CC-Link IE Field Network
communication unit
GT15-J71GF13-T2 50(1.97)
CC-Link communication unit
GT15-J61BT13,
GT15-75J61BT13-Z
31(1.38)
Printer unit GT15-PRN 36(1.42)