Mitsubishi GOT1000 GT15 - Communication Setting Contents

10.1 Communication Setting
10.1.3 Communication setting contents
10 - 3
9
UTILITY FUNCTION
10
COMMUNICATION INTERFACE SETTING
11
DISPLAY AND OPERATION SETTINGS
12
CLOCK SETTINGS AND BATTERY STATUS DISPLAY
13
FILE DISPLAY AND COPY
14
GOT SELF CHECK
15
CLEANING OF DISPLAY SECTION
16
MAINTENANCE TIME NOTIFICATION SETTING
10.1.3 Communication setting contents
This section describes setting items and display contents for Communication Setting.
(1) Channel-Driver assign
(a) Assignment of communication drivers to channels
Communication drivers installed in the GOT can be assigned to channels.
Even without setting [Controller Setting] on GT Designer3 or [Communication Setting] on GT
Designer2, communication with controller is available by assigning channel No. with this
function.
(
10.1.4 Channel-Driver assign operation)
(b) Changing the assignment of communication drivers to channels
Without using GT Designer3 or GT Designer2, the assignment of communication drivers to
channels can be changed.
(When change a communication driver, the alternative communication driver has to be
installed in GOT in advance.)
(2) Standard interface display BOX
Display the communication interface included as standard in GT15 .
There are the following 2 types.
RS232...For communicating with PC (GT Designer3 or GT Designer2), controller
USB.......For communicating with PC (GT Designer3 or GT Designer2)
(3) Extend interface display BOX
The name of the unit installed in the extend interface is displayed.
(Displays [None] when any unit is not mounted.)
For details of each uint, refer to the following.
8.1 Communication Unit
(2)
(4)
(4)
(3)
(5) (5)
(5)
(1)
(2)
GOT front face
USB interface (Standard interface)
GOT rear face
RS-232 interface (Standard interface)
Extend interface