5.1 Requirements to Meet EMC Directive
5 - 1
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
PART NAME AND
SETTINGS
5
EMC AND LOW
VOLTAGE
DIRECTIVE
6
INSTALLATION
7
WIRING
8
OPTION
5. EMC AND LOW VOLTAGE
DIRECTIVE
For the products sold in European countries, the conformance to the EMC Directive, which is one of the
European Directives, has been a legal obligation since 1996. Also, conformance to the Low Voltage
Directive, another European Directives, has been a legal obligation since 1997.
Manufacturers who recognize their products must conform to the EMC and Low Voltage Directive are
required to declare that their products conform to these Directives and put a "CE mark" on their products.
• Authorized representative in Europe
Authorized representative in Europe is shown below.
Name :Mitsubishi Electric Europe BV
Address :Gothaer strase 8, 40880 Ratingen, Germany
5.1 Requirements to Meet EMC Directive
EMC Directives are those which require "any strong electromagnetic force is not output to the external.:
Emission (electromagnetic interference)" and "It is not influenced by the electromagnetic wave from the
external.: Immunity (electromagnetic sensitivity)".
Items 5.1.1 thru 5.1.3 summarize the precautions to use GOT and configure the mechanical unit in order to
match the EMC directives.
Though the data described herein are produced with our best on the basis of the requirement items and
standards of the restrictions gathered by Mitsubishi, they do not completely guaranteed that all mechanical
unit manufactured according to the data do not always match the above directives. The manufacturer itself
which manufactures the mechanical unit must finally judge the method and others to match the EMC
directives.
To Next Page
Loading...
