Mitsubishi GOT1000 GT15 User Manual

8.12 Protective Sheet
8.12.2 Installing procedure
8 - 49
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
PART NAME AND SETTINGS
5
EMC AND LOW VOLTAGE DIRECTIVE
6
INSTALLATION
7
WIRING
8
OPTION
8.12.2 Installing procedure
1 Remove the old protective sheet from the GOT, and clean the GOT
surface.
2 Peel the release paper from the back of the new protective sheet, and
attach its adhesive side to the GOT display section.
When attaching the protective sheet, make sure to fit it on the display
section closely without leaving any clearance between them.
3 Peel the protective film off the protective sheet.
When the user continues using the GOT with the protective film, the film
may not be removed.
Remark
Replacement time of protective sheet
Check the status of the protection sheet visually by to the daily inspection.
The visibility becomes worse when there is too much dirt and cracks, causing
malfunction. Proceeds replacement promptly.

Mitsubishi GOT1000 GT15 Specifications

General

Display Size	10.4 inches
Display Type	TFT Color LCD
Resolution	640 x 480 pixels
Touch Panel Type	Analog resistive film
Power Supply	24V DC
Backlight	LED
Protection Rating	IP65 (front panel)
Interface	RS-232, RS-422/485, USB
Operating Temperature	0°C to 50°C
Memory	9 MB
Storage Temperature	-20 to 60°C
Display Colors	256 colors