Mitsubishi GOT1000 GT15 - Operating the System Alarm Display

14 - 36
14.9 System Alarm Display
14.9.3 Operating the system alarm display
14.9.3 Operating the system alarm display
1 System Alarm display resetting
(1) Before resetting the system alarm display in the GOT error
Eliminate the system alarm cause before resetting the system alarm display in the
GOT error.
If not eliminated, the system alarm display in the GOT error will not be reset even
after the reset operation.
(2) Processings with reset operation
The following data in the system information are also reset.
• GOT error code (Write device)
• GOT error detection signal (System Signal 2-1.b13)
1 Eliminate each cause of the system alarm
being occurred.
Error causes can be identified by the error
code, error message and channel No.
displayed on the System alarm display
screen.
(20. TROUBLESHOOTING)
2 A method for resetting system alarm
depends on an error.
•GOT error
Touch the button to reset system
alarms.
• CPU error and Network error
The system alarm is automatically reset
after its cause is eliminated.
Touch.
Reset