10 - 12
10.1 Communication Setting
10.1.4 Communication setting display operation
5 Setting of Host (PC)/Host (Modem)
The following describes how to set the [Host (PC)] and [Host (Modem)].
When setting [Host (PC)] for [PC connection type], the following settings are not required.
Set as follows only when selecting [Host (Modem)].
*1 The maximum number of characters of the AT command depends on the specifications of the modem.
When the maximum number of characters of the AT command which can be used for a modem is less than 255,
the initialize command is set according to the specifications of the modem.
Item Description Setting range
PC connection type Connecting method to the PC can be selected.
Host (PC)/Host (Modem)
<Default: Host (PC)>
Transmission Speed Set the transmission speed for communication.
9600/19200/38400/57600/115200
<Default: 115200>
Data Bit Set the data bit for communication. 7/8 <Default: 8>
Stop Bit Set the stop bit for communication. 1/2 <Default: 1>
Parity
Set whether to check the parity for
communication and select the format to check.
Odd/Even/None <Default: Odd>
Timeout Time(SEC.)
Displays the timeout time (sec.) for
communication.
<Default: 1 (fixed)>
Retry(TIMES)
Displays the number of retry (times) for
communication.
<Default: 1 (fixed)>
Init. AT command Set the AT command to initialize the modem.
English one byte characters within 255
characters
*1
<Default: AT&FE0%C0&K0&D0W2S0=1>
Modem operation
Touch the [Init.] button to initialize the modem.
Touch the [Disc.] button to disconnect the line.
-
To Next Page
Loading...
