Mitsubishi GOT1000 GT15 - Page 234

10 - 14
10.2 Communication Detail Settings
10.2.2 Communication detail settings display operation
2 The screen switches to the communication detail setting screen.
Set communication parameters from this screen.
Refer to the following for the setting change operation.
9.3.3 Basic operation of settings change
Communication parameter setting by GT Designer3 or GT Designer2
Set the communication parameters for each communication driver at
[Communication Settings] in [Controller Setting] of GT Designer3 or in [System
Environment] of GT Designer2.
When change the communication parameters after downloading project data,
change the setting at communication detail setting of GOT.
•GOT1000 Series Connection Manual
for GT Works3 and a controller used
•GT Designer2 Version Screen Design Manual
(3.7 Communication Interface Setting (Communication setting))
Communication parameter