13.3 Project Information
13.3.4 Operation of project information
13 - 19
9
UTILITY FUNCTION
10
COMMUNICATION
INTERFACE
SETTING
11
DISPLAY AND
OPERATION
SETTINGS
12
CLOCK SETTINGS
AND BATTERY
STATUS DISPLAY
13
FILE DISPLAY AND
COPY
14
GOT SELF CHECK
15
CLEANING OF
DISPLAY SECTION
16
MAINTENANCE
TIME NOTIFICATION
SETTING
3 Copy operation
Using the A drive and B drive, the following operations are possible.
Copying to another directory in the same drive
Copying between A drive and B drive
Copy to/from C drive is disabled.
(This item explains using the A drive.)
1 Install CF card in the PC, in which create
a folder for the copy destination.
Set the same character with [System
Information] of [Environmental Setting] of
GT Designer3 or with [System Setting] of
[System Environment] of GT Designer2
for the folder name.
• GT Designer3 Version1 Screen
Design Manual (Fundamentals)
(4.1 GOT Type Setting)
• GT Designer2 Version Screen
Design Manual
(3.1 GOT/Controller Type Setting)
2 Install the CF card mentioned above to
GOT.
Refer to the following for inserting/
removing method of CF card.
8.4 Video/RGB Unit
3 Open [Project Information] screen to
select the file to copy.
4 If touch button, the message
[Please select a destination.] is displayed
in the left bottom of the screen.
5 If the copy destination folder is touched,
the screen display is changed to the folder
of copy destination.
At this time, it cannot be copied into the
same folder where the file exists.
Select other folders.
To Next Page
Loading...
