Moons' M2 Series User Manual

M Series AC Servo
User Manual
66
Rev. 1.0
7/31/2019
400-820-9661
5.6 Parameter Setting Mode
5.6.1 Parameter Setting Description
The parameter setting mode (P+parameter number) allows you to select, display and edit the required
parameter. In function control mode, press and hold
for 1 second to enter parameter setting mode.
Use
to select required parameter, and press to view or edit the parameter. Press
again to quit and no change will be saved. Press and hold
for 1 second to save the parameter
change. However this change will NOT be saved at next power on.
If you want to save parameter PERMANENTLY, please go into function control mode (F+parameter
number), and use F-04SA function.
parameter setting
selection
Press UP and DOWN key
to select display detail.
S
press SET key to
enter parameter editing mode
press and hold SET key
to save parameter change
S
short press SET key
to quit
function selection
mode
M
press and hold MODE key
for 1 second

Moons' M2 Series Specifications

General

Brand	Moons'
Model	M2 Series
Category	Servo Drives
Language	English