MC2000 – Assembly Instruction Manual
26
8. Joint the chains. Lift the guide rail that is to
be jointed high enough above the lower
guide rail so that you can attach the con-
necting links.
9. Hold the chains in the upper guide rail with
e.
g. two screw drivers and loosen the chain
fixing device at the same time. Lower and
adjust the guide rail. Work carefully and
check that the steering pins enter the top
track properly.
10. Fasten the guide rails in the lift well with
sc
rews. Use 25 mm screws. Check that the
two C-profiles of the guide rails are in a po-
sition exactly opposite each other, so that
t
he lift moves softly past the joint.
11. Perform the same operation with the re-
maining guide rails..
To Next Page