Chapter
3
USB Communication
This chapter provides information for transferring files between the device and a host computer.
Connecting to a Host Computer via USB
Connect the MC67 to a host computer using the USB Charging cable or Single Slot USB cradle to transfer files
between the MC67 and the host computer.
Caution:
When connecting the MC67 to a host computer, follow the host computer’s instructions for connecting and
disconnecting USB devices, to avoid damaging or corrupting files.
Note: A microSD card must be installed in the MC67 to transfer files between the MC67 and host
computer.
Connecting to the MC67 as a Media Device
Procedure:
1 Connect the USB Charging cable to the MC67 and then to the host computer or place the MC67 into a Single Slot
USB cradle that is connected to a host computer.
Connected as a media device or Connected as an installer appears on the Status bar.
2 If Connected as an installer appears, pull down the Notification shade and touch Connected as an installer and
then touch Media device (MTP).
3 On the host computer, open a file explorer application.
4 Locate the MC67NA as a portable device.
5 Open the SD card folder.
6 Copy or delete files as required.
Connecting to the MC67 as an Installer
Procedure:
1 Connect the USB Charging cable to the MC67 and then to the host computer or place the MC67 into a Single Slot
USB cradle that is connected to a host computer.
Connected as a media device or Connected as an installer appears on the Status bar.
2 If Connected as media device appears, pull down the Notification shade and touch Connected as media device
and then touch Media device (MTP) to de-select.
3 Touch Turn on USB Storage.
4 On the host computer, open a file explorer application.
The MC67 storage appears as Removable Disk.
55 | USB Communication
MN000116A02-A | May 2015
To Next Page
Loading...
Need help?
General
