Replacing the microSD Card
Procedure:
1 If the MC67 is in a cradle, remove it before performing a Safe Battery Swap.
2 Unclip the handstrap.
3 Press and hold the Power button until the menu appears.
4 Touch Battery swap.
Figure 8: Power Button Menu
5 Wait for the red Data Capture LED to turn off.
6 Remove the battery.
7 Lift the rubber access door.
8 Slide SIM card holder door up to unlock.
9 Lift SIM Card holder door.
10 Lift the microSD card holder door.
11 Remove microSD card from holder.
12 Close microSD card holder door.
13 Close SIM card holder door.
14 Slide SIM card holder door down to lock into place.
15 Close the rubber access door.
16 Insert the battery, bottom first, into the battery compartment in the back of the MC67.
17 Press the battery down until the battery release latch snaps (two clicks) into place.
18 Replace the handstrap.
19 Press the Power button to wake the MC67.
20 If a SIM card is installed, perform a soft reset.
See Performing a Soft Reset on page 22.
Replacing the SIM Card
Procedure:
1 If the MC67 is in a cradle, remove it before performing a Safe Battery Swap.
2 Unclip the handstrap.
3 Press and hold the Power button until the menu appears.
4 Touch Battery swap.
5 Wait for the red Data Capture LED to turn off.
Getting Started | 21
MN000116A02-A | May 2015
To Next Page
Loading...
Need help?
General
