5 - 110 WiNG 5.5 Access Point System Reference Guide
14. Select OK to save the changes made within the Peer Configuration screen. Select Reset to revert to the last saved
configuration.
15. Select the Transform Set tab.
Create or modify Transform Set configurations to specify how traffic is protected within crypto ACL defining the traffic
that needs to be protected.
IP Type Enter either the IP address or FQDN hostname of the IPSec VPN peer used in the tunnel
setup. If IKEv1 is used, this value is titled IP Type, if IKEv2 is used, this parameter is titled
Select IP/Hostname.
Authentication Type or
Local Authentication Type
Select either pre-shared key (PSK) or RSA. Rivest, Shamir, and Adleman (RSA) is an
algorithm for public key cryptography. It’s the first algorithm known to be suitable for
signing, as well as encryption If using IKEv2, this screen displays both local and remote
authentication options, as both ends of the VPN connection require authentication. RSA
is the default value for both local and remote authentication (regardless of IKEv1 or
IKEv2).
Authentication Value or
Local Authentication Value
Define the authentication string (shared secret) that must be shared by both ends of the
VPN tunnel connection. The string must be from 8 - 21 characters long. If using IKEv2,
both a local and remote string must be specified for handshake validation and both ends
(local and remote) of the VPN connection.
Local Identity Select the access point’s local identifier used with this peer configuration for an IKE
exchange with the target VPN IPSec peer. Options include IP Address, Distinguished
Name, FQDN, email and string. The default setting is string.
Remote Identity Select the access point’s remote identifier used with this peer configuration for an IKE
exchange with the target VPN IPSec peer. Options include IP Address, Distinguished
Name, FQDN, email and string. The default setting is string.
IKE Policy Name Select the IKEv1 or IKE v2 policy name (and settings) to apply to this peer configuration.
If a policy requires creation, select the Create icon.
To Next Page
Loading...
