Device Configuration 5 - 131
Figure 5-81 Profile Security - Dynamic NAT tab
17. Refer to the following to determine whether a new Dynamic NAT configuration requires creation, edit or deletion:
18. Select Add to create a new Dynamic NAT configuration, Edit to modify an existing configuration or Delete to permanently
remove a configuration.
Source List ACL Lists the ACL defining packet selection criteria for the NAT configuration. NAT is applied
only on packets which match a rule defined in the access list. These addresses (once
translated) are not exposed to the outside world when the translation address is used to
interact with the remote destination.
Network Displays Inside or Outside NAT as the network direction for the dynamic NAT
configuration.
Interface Lists the VLAN (from 1 - 4094) used as the communication medium between the source
and destination points within the NAT configuration.
Overload Type Lists the Overload Type used with the listed IP ACL rule. Options include NAT Pool, One
Global Address and Interface IP Address. The default setting is Interface IP Address.
NAT Pool Displays the name of an existing NAT pool used with the NAT configuration.
Overload IP Enables the use of one global address for numerous local addresses.
ACL Precedence Lists the administrator assigned priority set for the listed source list ACL. The lower the
value listed, the higher the priority assigned to this ACL rule.
To Next Page
Loading...
