5 - 168 WiNG 5.5 Access Point System Reference Guide
12. Select the VLAN tab to display the link IP VLAN information shared by the devices managed by the MINT configuration.
The VLAN tab displays the VLAN, Routing Level, Link Cost, Hello Packet Interval and Adjacency Hold Time managed devices
use to securely communicate amongst one another.
Figure 5-105 Advanced Profile Configuration - MINT Protocol screen - VLAN tab
13. Select Add to create a new VLAN link configuration or Edit to modify an existing configuration.
IPSec GW Define either an IP address or hostname for the IPSec gateway.
NOTE: If creating a mesh link between two access points in Standalone AP mode, you
will need to ensure a VLAN is available to provide the necessary MINT link between the
two Standalone APs.
To Next Page
Loading...
