Device Configuration 5 - 335
26. Select the VLAN tab to display the link IP VLAN information shared by the access points managed by the MINT
configuration.
Figure 5-216 Device Overrides - Advanced Profile MINT screen - VLAN tab
The VLAN tab displays the VLAN, Routing Level, Link Cost, Hello Packet Interval and Adjacency Hold Time managed devices
use to securely communicate amongst one another.
27. Select Add to create a new VLAN link configuration or Edit to override an existing MINT configuration.
Adjacency Hold Time Set or override a hold time interval in either Seconds (2 - 600) or Minutes
(1 - 10) for the transmission of hello packets. The default interval is 46 seconds.
IPSec Secure Select this option to use a secure link for IPSec traffic. This setting is disabled by
default. When enabled, both the header and the traffic payload are encrypted.
IPSec GW Define either an IP address or hostname for the IPSec gateway.
NOTE: If creating a mesh link between two access points in Standalone AP mode, you’ll
need to ensure a VLAN is available to provide the necessary MINT link between the two
Standalone APs.
To Next Page
Loading...
