Over-the-Air Programming
Your dealer can remotely update your radio via Over-
the-Air Programming (OTAP) without physical
connection. Additionally, some settings can also be
configured via OTAP.
When your radio undergoes OTAP, the green LED
blinks.
When your radio receives high volume data:
• The display shows the High Volume Data icon.
• The channel becomes busy.
• A negative tone sounds if you press the PTT
button.
When OTAP completes, depending on the
configuration:
•
A tone sounds. The display shows Updating
Restarting. Your radio restarts by powering off
and on again.
•
You can select Restart Now or Postpone. When
you select Postpone, your radio returns to the
previous screen. The display shows the OTAP
Delay Timer icon until the automatic restart
occurs.
When your radio powers up after automatic restart:
•
If successful, the display shows Sw Update
Completed.
•
If unsuccessful, the display shows Sw Update
Failed.
See Checking Software Update Information on page
146 for the updated software version.
Selecting Third-Party Peripherals Connection Modes
Follow the procedure to select one of the following
third-party peripherals connection modes:
• Motorola
• PC and Audio
• Data Accessory
• Telemetry
• Generic
1
Press to access the menu.
2
Press
or to Utilities.Press to
select.
3
Press
or to Radio Settings.Press
to select.
124
English
To Next Page
Loading...
