Motorola XPR 5550 User Manual

If the call ends while you are entering the extra
digits requested by the call, your radio returns to
the screen you were on prior to initiating the call.
The DTMF Tone sounds. Your radio returns to the
previous screen.
9
Press to end the call.
10 If the deaccess code was not preconfigured, enter
the deaccess code when the display shows De-
Access Code:, and press to proceed.
The radio returns to the previous screen. The
DTMF Tone sounds and the display shows
Ending Phone Call.
If the call ends successfully:
• A tone sounds.
•
The display shows Call Ended.
If the call fails to end, the radio returns to the
Phone Call screen. Repeat Step 9 and Step 10, or
wait for the telephone user to end the call. When
you press the PTT button while in the Phone
Contacts screen, as tone sounds and the display
shows Press OK to Place Phone Call.
When the telephone user ends the call, a tone
sounds and the display shows Phone Call
Ended.
If the call ends while you are entering the extra
digits requested by the Phone Call, your radio
returns to the screen you were on prior to initiating
the call.
Note:
During the channel access, press to
dismiss the call attempt and a tone sounds.
During the call, when you press One Touch
Access button with the deaccess code
preconfigured or enter the deaccess code as
the input for extra digits, your radio attempts to
end the call.
During channel access and access/ deaccess
code or extra digits transmission, you radio
responds to On/Off button, Volume Knob,
and Channel Rocker only. A tone sounds for
every invalid input.
Making Phone Calls by Using the Alias Search
Capacity Max Operations
59
English

Motorola XPR 5550 Specifications

General

GPS	Yes
Bluetooth	Yes
IP Rating	IP54
Operating Temperature	-30°C to +60°C
Frequency Range	VHF: 136-174 MHz, UHF: 403-470 MHz
Weight	1.8 kg (4.0 lbs)
Display	Yes, Alphanumeric
Digital Protocol	DMR
Encryption	AES/DES Encryption
Channel Capacity	1000 channels