You can start and stop scanning by pressing the
programmed Scan button OR follow the procedure
described next.
1
to access the menu.
2
or to Scan and press to select.
3
or to Turn On or Turn Off and press
to select.
•
The display shows Scan On if scan is enabled.
•
The Scan menu shows Turn Off if scan is
enabled.
•
The display shows Scan Off if scan is
disabled.
•
The Scan menu shows Turn On if scan is
disabled.
Responding to a Transmission During a Scan
During scanning, your radio stops on a group where
activity is detected. The radio continuously listens for
any member in the scan list when idle on the control
channel.
1 Hold the microphone 1 to 2 inches (2.5 to 5.0 cm)
from your mouth.
2 Press the PTT button during hang time.
The LED lights up solid green.
3 Wait for the Talk Permit Tone to finish (if enabled),
and speak clearly into the microphone.
4 Release the PTT button to listen.
If you do not respond within the hang time, the
radio returns to scanning other groups.
User Configurable Scan
If the Edit List menu is enabled, a user is able to Add
and Remove the scan members from the Add
Member menu. A Scan List member must be a
regular Group Contact (i.e. not Multi-group or Site All
Call/Network Wide All Call) that is currently assigned
to a Channel Selector position in a Connect Plus
Zone with the same Network ID as the currently
selected Zone. The Talkgroup alias must not match
any Talkgroup that has been included in the current
Zone's Scan List.
Advanced Features in Connect Plus Mode
180
English
To Next Page
Loading...
