4 Wait for the Talk Permit Tone to finish (if enabled),
and speak clearly into the microphone.
5 Release the PTT button to listen.
When the target radio responds, the LED blinks
green, the radio unmutes and the response
sounds through the radio’s speaker. You see the
Group Call icon, the group alias or ID, and
transmitting radio alias or ID on your display.
If there is no voice activity for a predetermined
period of time, the call ends. Radio returns to the
screen you were on prior to initiating the call.
Making a Private Call
While you can receive and/or respond to a Private
Call initiated by an authorized individual radio, your
radio must be programmed for you to initiate a Private
Call.
You will hear a negative indicator tone, when you
make a Private Call via the One Touch Access
button, or the Channel Selector Knob, if this feature is
not enabled.
1 Do one of the following.
• Select the channel with the active subscriber
alias or ID. See Selecting a Call Type on page
163.
• Press the programmed One Touch Access
button.
2 Hold the microphone 1 to 2 inches (2.5 to 5.0 cm)
from your mouth.
3 Press the PTT button to make the call.
The LED lights up solid green. The Private Call
icon appears on the top right corner. The first text
line shows the target subscriber alias. The second
text line displays the call status.
4 Wait for the Talk Permit Tone to finish (if enabled),
and speak clearly into the microphone.
5 Release the PTT button to listen.
When the target radio responds, the LED blinks
green.
If there is no voice activity for a predetermined
period of time, the call ends. You hear a short
tone. The display shows Call Ended.
Your radio may be programmed to perform a radio
presence check prior to setting up the Private Call. If
Making and Receiving Calls in Connect Plus Mode
168
English
To Next Page
Loading...
Need help?
General
