MR TAPCON 230 basic - Instruction System

1 Introduction
14 TAPCON® 230 basic 2117246/02 EN © Maschinenfabrik Reinhausen 2012
1.6.4 Instruction system
This technical file contains single-step and multi-step instructions.
Single-step instructions
Instructions which consist of only a single process step are structured as fol-
lows:
Aim of action
Requirement (optional)
► Step 1 of 1
 Result of step (optional)
Result of action (optional)
(Figure optional)
Multi-step instructions
Instructions which consist of several process steps are structured as follows:
Aim of action
Requirements (optional)
 Requirement 1
 Requirement 2
1. Step 1
 Result of step (optional)
2. Step 2
etc.
Result of action (optional)
(Figure optional)