MR TAPCON 230 basic - Mounting; Unpacking Device

5 Mounting
© Maschinenfabrik Reinhausen 2012 2117246/02 EN TAPCON® 230 basic 35
5 Mounting
5.1 Unpacking device
The goods are packaged in a sturdy cardboard box. This ensures that the
shipment remains in the intended transport position and that none of its com-
ponents touches the load surface during transport or the floor after it is un-
loaded.
Inlays inside the box stabilize the goods, preventing impermissible changes of
position, and protect them from vibration.
Unpack the device as follows:
1.
Remove the lid from the lower part of the
cardboard box.
The upper inlay contains the accessories
supplied. The separate box labeled
"Documentation" contains all the device do-
cuments.
2. Check scope of supply for accessories.
3.
Take the box labeled "Documentation" out of
the cardboard box.