MR TAPCON 230 basic - Resetting Parameters

7 Functions and settings
© Maschinenfabrik Reinhausen 2012 2117246/02 EN TAPCON® 230 basic 147
7.5.6 Displaying MIO outputs
The statuses of the relays are shown in this display. As soon as a relay has
activated, status "1" is displayed. If status "0" is displayed, the relay hasn't ac-
tivated.
To display the "MIO outputs", proceed as follows:
► > Info > 5x .
<05> MIO outputs.
7.5.7 Resetting parameters
With this display you can reset your settings to the factory settings.
If you reset the parameters to the factory settings, then your settings are
permanently deleted.
To reset all the parameters, proceed as follows:
1. > Info > 6x .
<13> Default parameters.
2. Press
and at the same time.
"Default parameters active" is displayed.
All parameters have been reset to the factory set-
tings.