MR TAPCON 230 basic - Page 77

7 Functions and settings
© Maschinenfabrik Reinhausen 2012 2117246/02 EN TAPCON® 230 basic 77
To set the primary voltage, proceed as follows:
1.
> Normset > 2x .
<02> Primary voltage.
2. Press
to highlight the decimal place.
The decimal place is defined and the value
can be changed.
3. Press
to highlight a digit.
The digit position you want is highlighted
and the value can be changed.
4. Press
to increase the value or to
reduce it.
5. Press
.
The primary voltage is set.