Appendix
130
Troubleshooting Logic Problems, Continued
PROBLEM CAUSES SOLUTIONS
The numbers for a Chain of Wrong Dual Chain Module Change Dual Chain Module DIP
components are one number DIP Switch settings Switch #3 according to Appendix A
off
A Chain of components (not Wrong Dual Chain Module Change Dual Chain Module DIP
including Speakers) drops out DIP Switch settings Switch #4 to “component” (see
each time a component in Appendix A)
another Chain is selected
More than one component in Improperly set DIP switches Set DIP Switches on Switching
a Chain turns on at the same on Switching Module Modules according to Appendix A
time
Malfunctioning Switching Module Call MTi
One component is selected, Switching Module DIP Switch Check DIP Switch settings
but a different component incorrect
turns on
Malfunctioning Switching Check for LED activation light on
Module or cable Switching Module Check for loose
wires on each end of Control Cable
To Next Page
Loading...