To Next Page

To Previous Page

3-54

3.4 Setting Individual Autodialer Attributes

Thisfunctionallowstheusertocongureanindividualaddressbookentrywiththesettingsshownin

MemorySwitches010,011,012,013and014.

To set the individual attributes:

1.Changememoryswitch15,bit7to“1”.(See“3.3.1SettingtheMemorySwitches” for more informa-

tiononchangingmemoryswitch015.)

2. When the function is enabled, an “Attribute” option is added to the address book destination regis-

trationsteps.Asanaddressbookdestinationisprogrammed,anextrastepshowingAttribute1,

Attribute 2, Attribute 3, Attribute 4, and Attribute 5 are added as the last step.

3.Settheindividualbitpositionsasshowninthefollowingtable.Tochangeasetting,press or

untilthecursorisbelowthedesiredbitposition;thenpress“1”or“0”tomakethechange.

4.Press[Enter]tosavethesettingofthedisplayedattributeandadvancetothenextattribute.

5. To set the other attribute, repeat steps 3-4.

6.Whenthelastattributeisset,thefaxwilladvancetothenextautodialerprogrammingsteps.

Muratec MFX-2550 Field Engineering Manual

Other manuals for Muratec MFX-2550