Before using RJ-900X series OPERATION MANUAL
3-10
5. Operation panel displays "Ink Refill **min", and the initial ink replenishment starts.
• Ink replenishment takes about five minutes. Initial ink replenishment and pause operation are
repeated during initial filling.
• Confirm that conditions meet the following points during ink filling.
• Do not turn OFF the printer power.
• Do not pull out the printer power cable.
• Do not open the front cover.
• Do not push media loading lever to the back side.
6. After ink replenishment is completed, the operation panel displays "Paper End".
• If the printer is used just after initial filling completion, the following phenomena may occur.
• Printed line becomes blurred.
• White lines appear in the printed media.
• In such cases, perform head cleaning operations two to three times as shown in"
5.2.3 Head
cleaning
" before printing and check the results.
• If the trouble is not improved on the printed image even after performing head cleaning, leave the
printer unused for more than one hour. After that perform head cleaning once again and check the
printed image.
If the trouble is not improved on the printed image even after this, contact MUTOH local dealer.
To Next Page
Loading...
Need help?
General