User’s Guide ValueJet 1608 HS
Preparations before printing
AP-75810 - Revision 2.0 83
4
Step 18: Press Enter.
Start Confirmation adjustment printing.
When the Confirm Print is complete, the printer enters Normal.
Step 19: After the confirmation adjustment printing, cut the media.
Refer to Cutting media on page95
Step 20: Measure the distance between the two pluses in the confirmation print using a ruler.
Then, confirm that the distance matches the feeding length when printing.
If the distance does not match the feeding length, perform previous steps again.
If the distance matches the feeding length, proceed to the next step.
Step 21: Display the Media feed compensation menu on the operation panel in the same way
as previous.
Step 22: Press the + or – to select “PF4:Micro Print”.
N° Description
1
Feed length
2 Media feed direction
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
