Before using VJ-1628X OPERATION MANUAL
68 3.4 Filling ink
• Insert Ink cartridges all the way in Ink cartridge slots.
• When an Ink cartridge is installed, “Ink Refill **%” is displayed on Operation panel and ink
replenishment starts.
• Times required for the initial ink charge is as follows.
• Approx fifteen minutes
• Ink filling operation and pause operation are repeated during the initial ink replenishment.
• When “100%” is displayed, the initial ink replenishment is complete
• After the initial ink replenishment is complete, “Media End” is displayed on Operation panel.
• Comply strictly with the following during ink filling. If filling is interrupted, ink will
be lost when filling is resumed.
• Do not turn OFF the power of the printer.
• Do not unplug the power cord set of the printer.
• Do not open Front cover.
• Do not open Maintenance cover.
• Do not raise Media loading lever.
• Users cannot change the number of ink cartridge colors after the initial ink replenishment. To
request a change, contact your local MUTOH dealer.
• If the printer perform the nozzle check printing immediately after the initial ink replenishment is
complete, the following results may occur.
• Printed lines become blurred.
• The data is partially not printed.
In such cases, follow
5.3 Cleaning menu and refill a small amount of ink. Then, check the printing
result.
If there is no improvement in the print result even after refilling a small amount of ink, leave the
printer unused for an hour or more. Then, refill a small amount of ink again and check the print
result.
If there is still no improvement, contact your local MUTOH dealer.
To Next Page
Loading...
Need help?
General