8-1
8 Optional functions
Activating the CONFG menu
⇒ Press the CONF key.
The CONFG menu will open.
For Spectrum FFT and Harmonic Analysis modes only
For the Spectrum FFT and Harmonic Analysis modes, all settings in the
CONFG menu are possible only in the “RUN” state.
Tip: You can exit the CONFG menu in two ways:
Press the RUN key: Return to measurement screen
Press the ESC key: Return to previous menu
8.1 Selecting an alarm
For Field Strength and Exposure STD modes only
When the Alarm function is activated, a visible and (if required) audible
alarm signal is triggered when a defined alarm threshold is exceeded.
8.1.1 Activating the “ALARM” function
✓ The CONFG menu should be activated.
1. Use the UP/DOWN keys to select the “ALARM” function.
2. To activate the CONFG ALARM sub-menu, press the ENTER key.
Figure 8-1 CONFG ALARM menu
To Next Page
Loading...
