NARDA EFA-200 - 9 Device Data Memory; Calling up a Device Setting (User Setup); Scope and Content of the Default Settings (Factory Default Setup)

9-1
9 Device data memory
Whenever the EFA is switched on again, the settings that were active just
before it was last switched off will be re-activated.
Settings that you use often can be saved as a USER setup and re-activated
when needed.
9.1 Calling up a device setting (User Setup)
1. Press the USER key.
The USER menu opens.
2. Use the UP/DOWN keys to select a USER name.
3. Press key F4.
The settings saved under the selected USER name will be activated.
4. Press the ESC key to exit from the USER menu.
9.2 Scope and content of the default settings (Factory Default
Setup)
The data in Table 9.1 is stored by default in the Factory Default Setup and
in the four USER setups.
The Factory Default Setup cannot be changed, but the settings in the four
USER setups can be overwritten and saved under different names.
Saving device settings (User Setup): see page 9-4
The Factory Default Setup settings are shown in Table 9.1.
Parameter Section Value
Display mode Sect. 6 LIVE
Measurement range, E field Sect. 6 AUTO
Measurement range, B field Sect. 6 AUTO
CONFG menu
Limit curve from selection list Sect. 8.4 Index 1
Table 9-1 Factory Default Setup