8 Optional functions EFA-200/-300
8-6
✓ The CONFG menu should be activated.
1. Use the UP/DOWN keys to select the “STANDARDS” function.
2. To activate the CONFG STANDARDS sub-menu, press the ENTER key.
3. Use the UP/DOWN keys to highlight the required limit curve in black.
4. Press the ENTER key to confirm your selection.
The limit value curve is selected.
8.4 Selecting the measurement axis
Selection of the measurement axis specifies the main direction of the field
measurement. The following choices are available:
• Single axis measurement: Only the result for the chosen axis (X, Y, or Z)
is displayed.
• Triaxial measurement (isotropic): The main direction of the field is
determined from the coordinates of all three axes and is displayed.
✓ The CONFG menu should be activated.
1. Use the UP/DOWN keys to select the “CHANNELS” function.
2. To activate the CONFG CHANNELS sub-menu, press the ENTER key.
3. Use the UP/DOWN keys to select the desired measurement axis.
4. Press the ENTER key to confirm your selection.
Note: The selected measurement axis is shown as a subscript in the
display of the field quantity (e.g. B
X
= X channel of B-Field Probe).
The results of an isotropic measurement are shown without
subscript.
To Next Page
Loading...
