7 Measurement data memory EFA-200/-300
7-16
Selecting and displaying data sets
✓ The MEM SHOW menu is open.
1. Use the UP/DOWN keys to select a data set between 1 and the highest
number assigned.
– or –
1. Press the ENTER key to activate the data set number entry field.
The first digit field in the data set number is highlighted in black.
2. Use the UP/DOWN keys to change the number.
3. Press the NEXT key to move to the next entry field.
4. Repeat steps 2 and 3 for all remaining entry fields.
5. Confirm the changes by pressing ENTER.
The selected data set will be displayed.
Note: The selected data set number must be between 1 and the highest
assigned data set number (max. 4095). If this is not the case, the
data set with the highest number will be displayed automatically
when you press the ENTER key.
A beep will also be heard.
7.3 Exporting data
Stored measured values can be saved in a *.txt oder *.csv file and exported.
This means you can print out files or further process them with other
programs (e.g. a spreadsheet).
Stored measured values can be saved in a *.txt or *.csv file and exported.
This means you can print out files or further process them with other
programs (e.g. a spreadsheet).
Note: You must connect the basic unit to a PC if you want to transfer data
from the basic unit. If you want to export data directly from the E-
Field Unit, connect the E-Field Unit directly to the PC.
✓ Basic Unit or E-Field Unit is connected to a PC.
Setting up the EFA – PC connection: see page 10-6
✓ The software “EFA-200/-300 Tools” must be installed.
Installing the software “EFA-200/-300 Tools”: see page 10-5
1. Start the “Datalog.exe” application.
The “Datalog” window should open.
The data set types (“DataType”) and the number of data sets saved for
the respective data set types (“No.“) are displayed.
To Next Page
Loading...
