9 Device data memory EFA-200/-300
9-4
Activating the default setup
1. Press the USER key.
The USER menu opens.
2. Use the UP/DOWN keys to select the “FACTORY” function.
3. Press the ENTER key to confirm your selection.
The settings saved in the USER menus are retained. All other settings
are reset to the default values.
9.3 Saving device settings (User Setup)
You can save the device settings under a name of your choice (USER
name).
Note: For the modes Spectrum FFT and Harmonic Analysis, these settings
are possible only in the RUN state.
Opening the USER menu
⇒ Press the USER key.
The USER menu opens.
Entering a USER name
✓ The USER menu is open.
Note: The “FACTORY” function is pre-assigned and cannot be used to
save your own settings.
1. Use the UP/DOWN keys to select one of the four memory positions
(USER1 through USER4).
2. To activate the menu, press the ENTER key.
The first entry field of the USER name is highlighted in black.
3. Use the UP/DOWN keys to define the entry.
4. Use the NEXT key to move to the next entry field.
5. Repeat steps 3 and 4 for the remaining entry fields.
6. Press the ENTER key to confirm your entry.
The current settings will be saved under the USER name that you
entered.
7. Exit the USER menu by pressing key F1.
To Next Page
Loading...
