11 Remote control EFA-200/-300
11-6
Error message: “Q<n> FAILED - command ignored“
The remote control command was not executed since it does not agree with
the device status (e.g. measurement range switching during recording of
timer-controlled measurement sequences).
⇒ Check the device status.
Status messages
Message: “Q<n> OK”
Command C<n> was accepted and executed.
Message: “Q<n> FAILED - already running”
A timer-controlled measurement is being recorded.
Message: “Q<n> FAILED - not running”
A timer-controlled measurement cannot be terminated as there is no such
measurement running.
Message: “Q<n> FAILED matrix not open”
A spatial curve cannot be recorded because the function has not been
activated.
Message: “Q<n> FAILED- standard not available”
The selected limit value curve is not implemented.
⇒ Enabling operating modes: see page 10-9
Message: “LOCAL ALREADY OK”
The instrument is in LOCAL mode, i.e. it can only be operated using the
keyboard of the Basic Unit.
Message: “LOCAL OK”
The LOCAL command was accepted.
To Next Page
Loading...
