NARDA EFA-200 - Setting the Current Time; Setting the Date

8 Optional functions EFA-200/-300
8-10
8.8.2 Setting the current time
✓ The CONFG CLOCK sub-menu is activated.
Selecting the time display format
The time can be displayed using the 12-hour or 24-hour clock formats.
1. Use the UP/DOWN keys to select the “MODE” function (directly below
“TIME”).
2. Press the ENTER key until the required format (12-hour or 24-hour) is
set.
The time will be displayed in the selected format.
Setting the current time
1. Use the UP/DOWN keys to select the “TIME” function.
2. To activate the entry fields, press the ENTER key.
The first entry field is highlighted in black.
3. Use the UP/DOWN keys to define a value, bearing the display mode in
mind.
4. Press the NEXT key to move to the next entry field.
5. Repeat steps 3 and 4 for the remaining entry fields.
6. Press the ENTER key to complete entry.
The clock starts running from the set time (including the seconds).
8.8.3 Setting the date
✓ The CONFG CLOCK submenu should be activated.
Selecting the date display mode
The following formats are available for displaying the date:
1. Use the UP/DOWN keys to select the “MODE” function (directly below
“DATE”).
2. Press the ENTER key to confirm your selection.
3. Use the UP/DOWN keys to select the desired display mode.
4. Press the ENTER key to confirm your selection.
The date will be shown in the format you selected.
• DD.MM.YY Day.Month.Year
• MM/DD/YY Month/Day/Year
• YY-MM-DD Year-Month-Day