8 Setup and configure
90 NBM-550 Narda
8.1 Configuring the interface
You can use the serial interface via USB or an optical
connection.
Configuring the interface
Open the Serial Interface function (MAIN/INTERFACE/...).
Use the arrow keys ▲/▼ to select USB or Optical and
press the OK key.
Note: Logging parameters (e.g. the baud rate) are permanently
set and cannot be changed (see “Interfaces” on
page 125).
8.2 Saving and loading instrument settings
You can save your current instrument settings (setups) and
recall them when you need them again. Nine memory
positions are provided for such settings, so you can save
setups for different measurement tasks or for different
users, for example.
Note: You can use the NBM-TS PC software to store the setups
completely in the database and upload them to the
instrument again when they are needed.
Menu overview
Open the MAIN/SETUP menu.
Default These settings will be used when the instrument is
switched on as long as Power On = Default.
Setup 1-8 Memory positions
User Indicates that a user setup is stored at this
memory position
Factory Indicates that the factory default settings apply
because a user setup has not been stored
To Next Page
Loading...
Need help?
General
