8.4 Using the NBM-550 as a controller
Narda NBM-550 93
8.4 Using the NBM-550 as a controller
You can use the NBM-550 to control other instruments from
Narda Safety Test Solutions such as the NBM-520 or
another ▲/▼.
This allows you to measure in places that are difficult to
reach with convenient operation and reading of results.
Using the NBM-550 as a controller
1. Open the Controller Function function
(MAIN/INTERFACE/...).
2. Use the arrow keys ▲/▼ to select On and press the OK
key.
The PC interface is set to USB regardless of the set-
ting made in Serial Interface because the optical in-
terface is reserved for communication between
meters.
3. Connect the NBM-550 to the NBM-520 using an optical
cable.
You can then use the NBM-520 as an extended probe
handle.
All the measurement functions of the NBM-550 are
available.
Note: The probe must be connected to the NBM-520. Probes
connected to the NBM-550 will be ignored.
The display of the used probe type on the controller
(NBM-550) changes from Probe: to Remote: in order to
indicate an external probe (for example Remote: EF0391).
To Next Page
Loading...
