6 Measurements with the NBM-550 and EHP-50
66 NBM-550 Narda
To select the display mode:
✓ The display is in measuring mode.
1. Press the OK key to open the main menu.
2. Press the View key until the desired display mode is
shown.
3. Press the ESC key to switch to measuring mode.
6.3 General settings
The following settings are identical for all display modes and
so they are described together here. The functions specific
to each separate display mode are described in the sections
for each display mode.
Display wideband or peak value
You can display the numerical value referred to the
wideband measurement or to the peak value.
To switch the display:
1. Open the Frequency mode function
(MAIN MENU/MEASUREMENT SETTINGS/...).
2. Use the arrow keys ▲/▼ to select the desired setting and
press the OK key to confirm.
3. Press the ESC key twice to return to measuring mode.
Changing the field type and
measurement range
✓ The display is in measuring mode.
1. Press the OK key to open the main menu.
2. Press the left function key (E-field/H-field) several times
until the field type and measurement range are set as
you require (E-field: 1 kV/m > 100 kV/m > H-field: 10 mT
> 100 µT > ...).
3. Press the ESC key to switch to measure mode.
To Next Page
Loading...
Need help?
General
