6.9 Other settings
Narda NBM-550 77
Managing result data
Please refer to “Managing result data” on page 84 for
information. The results saved in EHP-50 mode are
indicated by the following abbreviations in the Data Viewer:
• LFS = Spectrum display mode
• LF% = Standard display mode
• LF3 = XYZ display mode
• LFM = Monitor display mode
• LFT = Timer Logging storage type
• WPV = Weighted Peak value (single measurement)
• WPH = Weighted Peak history (values versus time)
Saving and loading device settings
You can save and recall your device settings in a setup in
the same way as in HF mode. All EHP-50-specific settings
are saved separately. This also applies to the selected
standard.
See “Saving and loading instrument settings” on
page 90 for more information.
To Next Page
