8.2 Saving and loading instrument settings
Narda NBM-550 91
To delete a memory position:
Any saved instrument settings are deleted and the factory
default settings are substituted. The memory position is
retained.
Note: This function is not available unless User is displayed.
Use the arrow keys ▲/▼ to select the desired memory
position and press the Delete function key.
The user setup is deleted and Factory is displayed.
Restoring a setup
You can restore your own settings (User) or the factory
default settings (Factory).
Use the arrow keys ▲/▼ to select the desired memory
position and press the Load function key.
The instrument settings are restored (loaded).
Saving a setup
You can only store your own setups in memory positions
that are occupied with the factory default settings (Factory).
If you want to store your own settings in a memory position
that is occupied with a User setup, you will have to delete
this setup first (see “To delete a memory position:” on
page 91).
Use the arrow keys ▲/▼ to select the desired memory
position and press the Save function key.
The instrument settings are saved.
Changing a setup name
You can change the names of setups using the NBM-TS PC
software supplied with the device.
To change setup names:
1. Upload the setups to your PC using the NBM-TS PC
software.
2. Edit the names on your PC and then transfer the setups
back to the instrument.
To Next Page
Loading...
