3.1 Unpacking
Narda NBM-550 13
Unpacking the probes
1. Carefully open the foil bag to prevent damage to the
probes. Use a pair of scissors to cut open the outer edge
of the bag at the plug end of the probe.
2. Hold the probe by the plug body to remove it from the
bag.
3. Place the probe in the appropriate recess in the case to
store it safely.
The plastic bag is no longer needed and can be disposed of.
Note: Factory-fresh NBM probes are usually supplied sealed in a
plastic foil under vacuum. This prevents any degradation
due to moisture and means that the recommended
calibration interval can be increased by as much as 6
months. This is intended to ensure that the recommended
period of use of 24 months can still be achieved even if
delays occur in transit or due to customs procedures.
Transport damage
The addresses of your Narda Service Center are listed at
the end of this operating manual and on the Internet at
http://www.narda-sts.com.
NOTICE
Instrument/accessories damaged during
transportation
Using damaged instrument/accessories can lead to
subsequent damage.
Check the instrument and all accessories for damage
when you have unpacked them.
If the instrument is damaged, contact your Narda
Service Center.
To Next Page
Loading...
