Sampler parameters – page 5 of 6: LFO and DESTINATION in the software.
LFO
The LFO (Low Frequency Oscillator) is another modulation source based on waveforms with
different shapes.
LFO Controls Description
Type Here you can choose the shape of the LFO waveform. Available
shapes are Sine, Tri (Triangle), Rect (Rectangle), Saw, and Random.
Speed Controls the rate of the LFO measured in hertz (Hz). If you choose to
synchronize the Speed by activating Sync, it will show note values
instead of hertz.
Phase Defines the initial phase of the LFO waveform, from -0.50 to 0.50.
Sync The Sync selector is used to synchronize the LFO with the tempo of
your Project. If Free is selected, the LFO rate is independent of the
Project tempo. If Retrig or Lock is enabled, the values of the Speed
parameter will change into note values ranging from 16/1 (= one
modulation cycle in 16 bars) to 1/32 (one cycle in 1/32nd note) and
be synced with the Project tempo. While Retrig restarts the LFO at
each new note (each note has another LFO phase), Lock keeps the
LFO phase synchronized to the song position for all notes.
DESTINATION
This is where you define modulation targets for the LFO, i.e. the parameters you want this LFO
to control. The knobs adjust the amount of modulation for the following targets:
Working with Plug-ins
The Sampler Plug-in
MASCHINE - Manual - 285
To Next Page
Loading...
Need help?
General
