12.1.4 Limiter
The Limiter does two things: firstly it ensures that the signal level stays below 0 dB, thus pre-
venting digital clipping. But it can also increase the overall perceived volume by reducing the
threshold. It is recommended to place the Limiter in a Master Plug-in slot. However, please
note that the Limiter introduces a small latency (or processing delay, see chapter ↑18, Glossa-
ry for a definition).
If this effect is used in a Sound or a Group, it also provides a Side-Chain Input page (in the
Control area and on your controller).
The Limiter panel in the Plug-in Strip.
Main Page
The Limiter in the Control area: Main page.
Effect Reference
Dynamics
MASCHINE - Manual - 616
To Next Page
Loading...
