Quickly Setting the Loop Range to the Entire Project
You can quickly select all Scenes in one go:
►
Press SCENE + Button 3 (ALL) to include all available Scenes in the Loop Range.
This command is not available if ARRANGE (Button 2) is enabled.
If you want to set the Loop Range back to a particular Scene, press SCENE + the desired pad
as described above.
You can also do this at any time without switching your controller to any particular mode:
Press SHIFT + RESTART (LOOP on older models) to switch the Loop Range between all Scenes and the selected Scene.
►
Press SHIFT + RESTART (LOOP on older models) to switch the Loop Range between all
Scenes and the selected Scene.
13.3.2 Jumping to Other Scenes
If you set a new Loop Range by selecting another Scene or group of Scenes as described in
section ↑13.3.1, Selecting a Loop Range, the playback will jump to the new Loop Range. This
way you can easily move the playback position to other Scenes and adapt your song live.
Creating a Song Using Scenes
Playing with Scenes
MASCHINE - Manual - 742
To Next Page
Loading...
