→
As long as you hold the pad, the corresponding events are deleted as the playhead moves
on.
You can use this to selectively erase notes at a particular place in the Pattern.
This might take some time getting used to, especially when the tempo is very fast, but
you can always use undo/redo (SHIFT + pad 1, SHIFT + pad 2) to get back to where you
were before.
Deleting Events for the Entire Group at Playback Position
â–º
While the Pattern is playing, hold ERASE + GROUP + the desired pad 9–16 to progres-
sively delete events for all Sounds in that Group as they are reached by the playhead.
Deleting Events or Notes via the Transport Functions
If the sequencer is not playing, you can erase events on either side of the playhead by manual-
ly moving the playhead:
â–º
While playback is off, hold ERASE and press the Locate buttons (in the TRANSPORT sec-
tion) to jump to the previous/next step and delete all events found on the way for the se-
lected Sound(s).
Please note the following:
▪ If multiple Sounds are selected, all of them will be affected. See section ↑4.1.3, Selecting
Multiple Sounds or Groups for more information.
▪ The jumps are based on the step size, that is on the Step Grid setting. See section ↑7.1.7,
Adjusting the Step Grid and the Nudge Grid for more information.
â–ª The command has the same effect whether your pads are in Group mode or in Keyboard
mode.
7.4.6 Cut, Copy, and Paste Events/Notes
You can also cut, copy and paste selected events to another location in the same Pattern or to
a different pattern and for the same Sound or another one (possibly in another Group).
To cut, copy, and paste the selected events/notes in the software, do the following:
Working with Patterns
Editing Events
MASCHINE - Manual - 351
To Next Page
Loading...
Need help?
General
