â–º
Click and drag the Scene end marker to the left.
→
The Clip will be shortened, and if the adjustment is shorter than the referenced Pattern a
small Truncated Clip marker will appear on the right-hand side of the Scene to indicate
that a section of the Clip is hidden. Only the visible part of the Clip will be audible during
playback.
When adjusting the size of a Scene the following rules apply:
â–ª The value set in the Arrange Grid is used for length increments.
â–ª When [Shift] is pressed while changing the length, the value set in the Step Grid is used.
â–ª The minimum length a Scene marker can be dragged without modifier is one Arrange Grid
increment.
â–ª When [Shift] is pressed, the minimum length a Scene marker can be dragged is one Step
Grid increment.
â–ª The minimum length of a Scene equals the minimum Pattern length. This can only be ach-
ieved if Arrange Grid or Step Grid is set to Off.
13.2.11.2 Adjusting the Length of a Scene Using the Controller
To adjust the length of a Scene using your hardware controller:
1. Press the SCENE button to enter the Scene page.
Creating a Song Using Scenes
Managing Scenes
MASCHINE - Manual - 733
To Next Page
Loading...
Need help?
General
