Native Instruments Maschine User Manual

Prelistening to the input signal.
Furthermore, If you have selected an external signal (EXT. STER. or EXT. MONO selected in
SOURCE), an additional MONITOR section is available by pressing the Right Page button. In
this section, using Knob 1 you can set MONITOR to ON in order to send the input signal to the
Cue bus of MASCHINE, allowing you to hear on a separate channel (e.g., your headphones) the
audio source that is about to be recorded.
For more information on how to use the Cue bus, please refer to section ↑9.2.6, Using
the Cue Bus.
14.2.3 Arming, Starting, and Stopping the Recording
The Start and Cancel buttons.
►
Click Start to arm the recording.
After the recording has been armed, its behavior will depend on the recording mode you have
selected (via the MODE selector, see section ↑14.2.2, Selecting the Source and the Recording
Mode above):
▪ When recording in Sync mode:
◦ The recording will start at the next bar. Until then the Start button reads a flashing
Waiting label and the Waiting for the next bar… message appears in the information
bar above the waveform display.
Sampling and Sample Mapping
Recording a Sample
MASCHINE - Manual - 759

Native Instruments Maschine Specifications

General

Weight	4.85 lbs (2.2 kg)
Pads	16 velocity-sensitive pads with aftertouch
Connectivity	USB, MIDI In/Out
Software	Maschine Software
Compatibility	Mac and PC
Power Supply	USB powered
Audio Interface	No built-in audio interface
Sequencer	Yes, pattern-based sequencer
Sampling	Yes, integrated sampler
Effects	Yes, includes a variety of effects
Encoders	8 knobs with LED ring indicators
DAW Integration	Yes, works as a plugin within most major DAWs