On your controller:
►
Press SHIFT + REC to start the Count-in and record in Overdub mode.
or
►
Press SHIFT + ERASE + REC to start the Count-in and record in Replace mode (see sec-
tion ↑7.2.1, Recording Your Patterns Live for more information on the Replace mode).
Adjusting the Count-in Duration
You can adjust the duration of the Count-in in the recording settings:
1. Press SHIFT + GRID to show the record settings.
2. Turn Knob 3 (LENGTH) to select a duration for the Count-in.
7.2.5 Quantizing while Recording
You can choose to have notes automatically quantized as you record them on the pads. This is
called Input Quantization.
You can also quantize recorded notes at any time. See section ↑7.4.7, Quantizing
Events/Notes for more information.
Using Input Quantize on Your Controller
1. Press SHIFT + GRID to show the record settings.
2. Turn Knob 4 (QUANTIZE MODE) to enable (ON) or disable (OFF) Input Quantization.
Working with Patterns
Recording Patterns in Real Time
MASCHINE - Manual - 328
To Next Page
Loading...
