For more information on the Pattern Grid, see section ↑7.1.6, Adjusting the Pattern Grid
and the Pattern Length.
Jumps Based on the Step Grid
You can also jump by finer increments:
►
Hold SHIFT and press the Locate buttons (showing left/right arrows) in the TRANSPORT
section to jump to the previous/next step, according to the current Step Grid settings.
→
Depending on the playback state, the following will happen:
▪
If playback is off, the playhead jumps to the beginning of the previous/next step.
▪ If playback is on, the playhead jumps to the same relative position in the previous/next
step.
If the Step Grid is disabled (i.e. set to OFF), the jumps are based on bars.
For more information on the Step Grid, see section ↑7.1.7, Adjusting the Step Grid and
the Nudge Grid.
13.1.5 Creating and Removing Clips
Each Clip placed in the Arranger references one of the Patterns available in the Pattern Editor
for the corresponding Group. Therefore, “creating a Clip” means “creating a reference to the
desired Pattern in the selected Scene,” while “deleting a Clip” means “removing the reference
to the Pattern from the Scene.”
In the Arranger, each column represents a Scene and each row represents a Group.
Creating a Song Using Scenes
Arranger Basics
MASCHINE - Manual - 700
To Next Page
Loading...
Need help?
General
